What We Offer

Ridgeline Clips is a company, with over 40 years of Experience in both Onshore and Offshore Oil, Gas and LNG Facilities, that has developed a Tubing Clamp to solve the problem of Crevice or Galvanic Corrosion on stainless steel tubing within the tubing support system.

The tubing clamps that are being used today are too tight, deform around the tubing when tightened down or just encapsulate the tubing creating a saddle that will hold water and debris.  Due to the lack of air flow the tubing is not allowed to dry out, and the corrosion process begins.  Tubing support systems on the market today are inefficient at preventing crevice or galvanic corrosion on tubing run(s) and, as a result, tubing failure will result creating an unnecessary expense of repair or replacement.

About Our Company

RIDGELINE clAMps

• Made in the USA
  
• Ridges that lift tubing up and away from debris build-up in the clamp
  
• Limited contact at the hold down point
  
• Provides Air Gaps around the tubing, which allows for a quicker dry out time
  
• Provides greater spacing between parallel tubing runs, which prevents debris build-up or water drops sticking between tubing runs
  
• Clamps design prevents over tightening and the deformation around the tubing
• Tubing sizes 1/4″, 3/8″, 1/2″, 9/16″, 3/4″ and 1″
  
• Multiple lengths and combinations
  
• Multiple options for mounting (Direct Bolt, Hilti, Unistrut, Tray, Drill and Tap)
  
• Easy installation with no customization required in the field
  
• Crevice and Galvanic Corrosion Prevention​
• ​Custom Designs to meet the requirements of your Project - Give us a call​​

Material:

• High Density Polyethylene (HDPE) UL Listed
• Ultra-Violet resistant (UV)
• Chemical Resistant
  
• Vicat Softening Temperature 255 degrees F
  
• Brittleness Temperature -103 degrees F
  
• Non-Abrasive
  
• Stress crack resistant
  
• ​No gases emitted when heated
  
• No water absorption
  

Delivers:

• Lower Material Cost
• Lower Labor Cost
  
• Extended Tubing Life